McCulloch B26PS Manuel de l'opérateur télécharger pdf (Page 11)

ASSEMBLY

English

– 11

Fitting the P-barrier

Clip the loop handle with the P-barrier onto the shaft. Note

that the loop handle must be ﬁtted between the arrows on

the shaft.

• Fit the bolt, securing plate and wing nut as shown in

the diagram. Tighten the wing nut.

Assembling and dismantling the

two-piece shaft

Assembly:

• Loosen the coupling by turning the knob.

• Align the tab of the attachment (A) with the hole in the

coupling (B).

• Push the attachment into the coupling until the

attachment snaps into place.

• Before using the unit, tighten the knob securely.

Dismantling:

• Loosen the coupling by turning the knob (at least 3

times).

• Push and hold the button (C). While securely holding

the engine end, pull the attachment straight out of the

coupling.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 81 82

Pas de commentaire

McCulloch B26PS Manuel de l'opérateur Page 11