McCulloch B26PS Manuel de l'opérateur télécharger pdf (Page 24)

MAINTENANCE

24 – English

Bevel gear

The bevel gear is ﬁlled with the right quantity of grease at

the factory. However, before using the machine you

should check that the bevel gear is ﬁlled three-quarters

full with grease. Use HUSQVARNA special grease.

The grease in the bevel gear does not normally need to

be changed except if repairs are carried out.

Checking and adjusting of throttle

wire

Make sure the throttle cable is tight enough without giving

the product gas and cutting equipment starts rotate. The

throttle cable should not be too loose so the product does

not reached full throttle.

Adjust the nut on the throttle cable with the nut. Then

tighten the lock nut.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 81 82

Pas de commentaire

McCulloch B26PS Manuel de l'opérateur Page 24